RYZE Tello 8520 Coreless Genuine CW CCW Motor for DJI Tello 720P Camera WiFi FPV Mini Drone Quadcopter Repair Accessories (Genuine M4 Motor (Long Black/Blue Line))


Price: $11.00
(as of Oct 21,2020 18:44:30 UTC – Details)


RYZE Tello 8520 Coreless Genuine CW CCW Motor for DJI Tello 720P Camera WiFi FPV Mini Drone Quadcopter Repair Accessories

Specification: Item name: RYZE DJI Tello Genuine 8520 Coreless CW CCW Motors
Voltage: DC 3.7V
Shaft end play: 0.05-0.3mm
No-load speed: 52000±10%RPM
No-load current: 93mA (MAX)
Load speed: 24200±6%RPM
Load current: 2200mA (MAX)
Starting voltage: 0.8V DC (MAX)
Dielectric strengt: 5MΩ (MIN)
Gross weight: 5.5g/pc

Introduction This a motor replacement guide for the Ryze/DJI Tello. It require fine soldering and very careful motor installation.

Step 1 install motor connectors – pull motor wires out of the arm/mount (does not require opening the drone or removing any screws). Pull the motor outs of the motor mount, not out of the main body.
black -> black, white -> white
blue -> black, red -> blue

Step 2 install motors into mounts – fold wires to the side of the motor
wires should be parallel and straight
each wire aligns with a small grovve, or both wires together in one of the larger grooves
for neater installation, wrap wires around the arms so that the connectors are meeting between the two struts of each arm

Step 3 remove pinions and install motors remove the white pinions and discard, e.g. with small pliers or flat screw driver. Dont bend the shaft, be careful!
install propellers
CW – front/left & rear/right
CCW – rear/left & front/right
After installation of the motor connectors, future motor swap will be much easier.

Perfectly Genuine replace the motors of DJI Tello 720P Camera WiFi FPV RC Quadcopter
M1, M2, M3, M4 CW CCW coreless motor kit is very powerful and durable, keep the quadcopter safe.
RYZE Tello 8520 Coreless Genuine Powerful motors perform great when speed up, quickly increase or decrease altitude, and stop immediately.
– fold wires to the side of the motor wires should be parallel and straight each wire aligns with a small grovve, or both wires together in one of the larger grooves for neater installation, wrap wires around the arms so that the connectors are meeting between the two struts of each arm
remove the white pinions and discard, e.g. with small pliers or flat screw driver. Dont bend the shaft, be careful! install propellers CW – front/left & rear/right CCW – rear/left & front/right




Leave a Reply

Your email address will not be published. Required fields are marked *